Synthesis and Characterization of ZrO2:ZnO Nanoparticles Prepared by Laser Induced Plasma

Authors

  • Marwa A. Mohammed Department of Physics, College of Science, Al-Nahrain University, Baghdad, Iraq
  • Hassan Nasir Hashim AlNahrain University/College of Science

Keywords:

Laser induced Plasma, ZrO2:ZnO, XRD, AFM, UV-VIS spectroscopy

Abstract

In this research, we looked at how laser energy affected the structural and optical characteristics of ZrO2:ZnO thin films at mixing ratios (0.1, 0.2, 0.3 and 0.4) that were applied on glass slides using the pulse laser deposition technique (PLD). Nd:YAG laser was utilized with a wavelength of 1064 nm, a pulse width of 9 ns, and an energy of 320 mJ. The X-ray diffraction patterns revealed that all the films had a polycrystalline hexagonal crystal structure. AFM was used to measure the topography of the film's surface, and the results revealed that the average roughness and grain size increased. After analyzing the optical characteristics of each film, it was discovered that the absorption coefficient in the 200–1000 nm wavelength range increases at 320 mJ of laser energy and that the optical energy gap value for indirect permitted transitions decreases between 3.58 and 3.4 eV.

References

Ashfold, M.N.R.; Claeyssens, F.; Fuge, G.M.; Henley, S.J.; “Pulsed laser ablation and deposition of thin films”. Chem. Soc. Rev., 33(1): 23–31, 2004.

Hubler, G.K.; “Pulsed laser deposition”. MRS Bull., 17: 26–29, 1992.

Aksoy, S.; Caglar, Y.; Ilican, S.; Caglar, M.; “Effect of heat treatment on physical properties of CdO films deposited by sol–gel method”. Int. J. Hydrogen Energy, 34(12): 5191–5195, 2009.

Srinatha, N.; Raghu, P.; Mahesh, H. M.; Angadi, B.; “Spin-coated Al-doped ZnO thin films for optical applications: Structural, micro-structural, optical and luminescence studies”. J. Alloys Compd., 722: 888–895, 2017.

Hasabeldaim , E.; Ntwaeaborwa, O. M.; Kroon, R. E.; Coetsee, E.; Swart, H. C.;“Effect of substrate temperature and post annealing temperature on ZnO: Zn PLD thin film properties”. Opt. Mater. (Amst). 74: 139–149, 2017.

Mustafa, S. K.; Jamal, R. K.; Aadim, K. A.; “Studying the effect of annealing on optical and structure properties of ZnO nanostructure prepared by laser induced plasma” Iraqi J. Sci.,60(10): 2168–2176, 2019.

Shan, F. K.; Shin, B. C.; Jang, S. W.; Yu, Y. S.; “Substrate effects of ZnO thin films prepared by PLD technique”. J. Eur. Ceram. Soc., 24(6): 1015–1018, 2004.

Mani, G. K.; Rayappan, J. B. B.; “A highly selective and wide range ammonia sensor—Nanostructured ZnO: Co thin film”. Mater. Sci. Eng. B, 191: 41–50, 2015.

Larbah, Y.; Adnane, M.; Sahraoui, T.; “Effect of substrate temperature on structural and optical properties of spray deposited ZnO thin films”. Mater. Sci., 33(3): 491–496, 2015.

Shan, F. K.; Yu, Y. S.; “Band gap energy of pure and Al-doped ZnO thin films”. J. Eur. Ceram. Soc., 24(6): 1869–1872, 2004.

Craciun, V.; Elders, J.; Gardeniers, J. G. E.; Boyd, I. W.; “Characteristics of high quality ZnO thin films deposited by pulsed laser deposition”. Appl. Phys. Lett., 65(23): 2963–2965, 1994.

Vanalakar, S. A.; Agawane, G.L.; Shin, S.W. ; Suryawanshi, M.; Gurav, K.V.; Patil, P.S.; Jeong, C.; Kim, J.Y.S.; Kim, J.H.; “A review on pulsed laser deposited CZTS thin films for solar cell applications”. J. Alloys Compd., 619: 109–121, 2015.

Fan, X. M.; Lia, J. S.; Guo, Z. X.; Lu, H. J.; “Microstructure and photoluminescence properties of ZnO thin films grown by PLD on Si (1 1 1) substrates”; Appl. Surf. Sci., 239(2), pp. 176–181, 2005.

Kumar, V.; Ntwaeaborwa, O. M.; Swart, H. C.; “Deep level defect correlated emission and Si diffusion in ZnO: Tb3+ thin films prepared by pulsed laser deposition”; J. Colloid Interface Sci., 465: 295–303, 2016.

Horti, N. C.; Kamatagi, M. D.; Nataraj,S. K.; Wari , M. N.; Inamdar, S. R.; “Structural and optical properties of zirconium oxide (ZrO2) nanoparticles: effect of calcination temperature”. Nano Express, 1(1): 10022, 2020.

Rossall, A. K., “Characterisation and Measurement of Laser Produced Plasma Emission and Applications in Opacity Experiments”. PhD. Thesis. University of York. 2011.

Wang, X.; Zhai, B.; Yang, M.; Han, W.; Shao, X.; “ZrO2/CeO2 nanocomposite: Two step synthesis, microstructure, and visible-light photocatalytic activity”. Mater. Lett. , 112: 90–93, 2013.

Zhang, X.; Su, H.; Yang, X.; “Catalytic performance of a three-dimensionally ordered macroporous Co/ZrO2 catalyst in Fischer–Tropsch synthesis”. J. Mol. Catal. A Chem., 360: 16–25, 2012.

Gusmano, G.; Montesperelli, G.; Rapone, M.; Padeletti, G.; Cusmà, A.; Kaciulis, S.; Mezzi, A.; Di. Maggio, R.; “Zirconia primers for corrosion resistant coatings”. Surf. Coatings Technol., 201(12): 5822–5828, 2007.

Zhang, C.; Li, C.; Yang, J.; Cheng, Z.; Hou, Z.; Fan, Y.; Lin, J.; “Tunable luminescence in monodisperse zirconia spheres”. Langmuir, 25(12): 7078–7083, 2009.

Najibi-Ilkhechi, N.; Koozegar-Kaleji, B.; Salahi, E.; “Effect of heating rate on structural and optical properties of Si and Mg co-doped ZrO _ 2 ZrO 2 nanopowders”. Opt. Quantum Electron. 47: 1187–1195, 2015.

Fritzen, D. L.; Giordano, L.; Rodrigues, L. C. V; Monteiro, J. H. S. K.; “Opportunities for persistent luminescent nanoparticles in luminescence imaging of biological systems and photodynamic therapy”. Nanomaterials, 10(10): 1-36, 2020.

Zhu, H.; Yang, D.; Xi, Z.; Zhu, L.; “Hydrothermal synthesis and characterization of zirconia nanocrystallites”. J. Am. Ceram. Soc., 90(4): pp. 1334–1338, 2007.

Purohit, R. D.; Saha, S.; Tyagi, A. K.; “Combustion synthesis of nanocrystalline ZrO2 powder: XRD, Raman spectroscopy and TEM studies”. Mater. Sci. Eng. B, 130(1-3): 57–60, 2006.

Lan, L.; Chen, S.; Cao, Y.; Zhao, M.; Gong, M.; Chen, Y.; “Preparation of ceria–zirconia by modified coprecipitation method and its supported Pd-only three-way catalyst”. J. Colloid Interface Sci., 450: 404–416, 2015.

Wang, J. A.; Valenzuela, M. A.; Salmones, J.; Vázquez, A.; Garcıa-Ruiz, A.; Bokhimi, X.; “Comparative study of nanocrystalline zirconia prepared by precipitation and sol–gel methods”. Catal. Today, 68(1-3): 21–30, 2001.

Hernandez-Como, N.; Martinez Landeros, V.; Mejia, I.; Aguirre Tostado, F.S.; Nascimento, C.D.; deM.Azevedo, G.; Krug, C. ; Quevedo-Lopez , M.A.; “Defect control in room temperature deposited cadmium sulfide thin films by pulsed laser deposition”. Thin Solid Films, 550: 665–668, 2014.

Gokulakrishnan, V.; Parthiban, S.; Jeganathan, K.; Ramamurthi, K.; “Investigation on the effect of Zr doping in ZnO thin films by spray pyrolysis”. Appl. Surf. Sci., 257(21): 9068–9072, 2011.

Lee, J.-H.; Song, J. T.; “Dependence of the electrical and optical properties on the bias voltage for ZnO: Al films deposited by rf magnetron sputtering”. Thin Solid Films, 516(7): 1377–1381, 2008.

Hussain, J. M.; Jasim, A.S.; Aadim, K. A.; “Synthesis and Characterization of CdOx− 1∶ MgX films by pulsed laser deposition”. Iraqi J. of Physics,18(45): 59-67, 2020.

Mohammed, R. S.; Aadim, K.A.; Ahmed, K.A.; “Synthesis of CuO / ZnO and MgO / ZnO Core / Shell Nanoparticles with Plasma Jets and Study of their Structural and Optical Properties”. Karbala Int. J. of Modern Science. 8(2): 213-222. 2022.

Downloads

Published

2024-02-01

Issue

Section

Articles

How to Cite

(1)
Synthesis and Characterization of ZrO2:ZnO Nanoparticles Prepared by Laser Induced Plasma. ANJS 2024, 26 (4), 73-79.